Fermi_energy

Not to be confused with Fermi level.

The Fermi energy is a concept in quantum mechanics usually referring to the energy of the highest occupied quantum state in a system of fermions at absolute zero temperature. This article requires a basic knowledge of quantum mechanics.

Note that the term "Fermi energy" is often, confusingly, used to describe a different but closely-related concept, the Fermi level (also called chemical potential).^[1] The Fermi energy and chemical potential are the same at absolute zero, but differ at other temperatures, as described below.

1 Introduction
- 1.1 Context
- 1.2 Advanced context
2 Illustration of the concept for a one dimensional square well
3 The three-dimensional case
4 Typical Fermi energies
- 4.1 White dwarfs
- 4.2 Nucleus
5 Pinning of Fermi level
6 Free electron gas
7 See also
8 References
9 External links

Introduction

Context

In quantum mechanics, a group of particles known as fermions (for example, electrons, protons and neutrons are fermions) obey the Pauli exclusion principle, which states that no two fermions can occupy the same quantum state. The states are labeled by a set of quantum numbers. In a system containing many fermions (like electrons in a metal) each fermion will have a different set of quantum numbers. To determine the lowest energy a system of fermions can have, we first group the states into sets with equal energy, and order these sets by increasing energy. Starting with an empty system, we then add particles one at a time, consecutively filling up the unoccupied quantum states with the lowest energy. When all the particles have been put in, the Fermi energy is the energy of the highest occupied state. What this means is that even if we have extracted all possible energy from a metal by cooling it down to near absolute zero temperature (0 kelvins), the electrons in the metal are still moving around; the fastest ones would be moving at a velocity that corresponds to a kinetic energy equal to the Fermi energy. This is the Fermi velocity. The Fermi energy is one of the important concepts of condensed matter physics. It is used, for example, to describe metals, insulators, and semiconductors. It is a very important quantity in the physics of superconductors, in the physics of quantum liquids like low temperature helium (both normal and superfluid ³He), and it is quite important to nuclear physics and to understand the stability of white dwarf stars against gravitational collapse.

Advanced context

The Fermi energy (E_F) of a system of non-interacting fermions is the increase in the ground state energy when exactly one particle is added to the system. It can also be interpreted as the maximum energy of an individual fermion in this ground state. The chemical potential at zero temperature is equal to the Fermi energy.

Illustration of the concept for a one dimensional square well

The one dimensional infinite square well of length L is a model for a one dimensional box. It is a standard model-system in quantum mechanics for which the solution for a single particle is well known. The levels are labeled by a single quantum number n and the energies are given by

$E_n = \frac{\hbar^2 \pi^2}{2 m L^2} n^2 \,$ .

Suppose now that instead of one particle in this box we have N particles in the box and that these particles are fermions with spin 1/2. Then only two particles can have the same energy i.e. two particles can have the energy of $E_1=\frac{\hbar^2 \pi^2}{2 m L^2}$ , or two particles can have energy $E 2 = 4 E 1$ and so forth. The reason that two particles can have the same energy is that a spin-1/2 particle can have a spin of 1/2 (spin up) or a spin of -1/2 (spin down), leading to two states for each energy level. When we look at the total energy of this system, the configuration for which the total energy is lowest (the ground state), is the configuration where all the energy levels up to n=N/2 are occupied and all the higher levels are empty. The Fermi energy is therefore

$E_f=E_{N/2}=\frac{\hbar^2 \pi^2}{2 m L^2} (N/2)^2 \,$ .

The three-dimensional case

The three-dimensional isotropic case is known as the Fermi sphere.

Let us now consider a three-dimensional cubical box that has a side length L (see infinite square well). This turns out to be a very good approximation for describing electrons in a metal. The states are now labeled by three quantum numbers n_x, n_y, and n_z. The single particle energies are

$E_{n_x,n_y,n_z} = \frac{\hbar^2 \pi^2}{2m L^2} \left( n_x^2 + n_y^2 + n_z^2\right) \,$

n_x, n_y, n_z are positive integers.

There are multiple states with the same energy, for example $E 100 = E 010 = E 001$ . Now let's put N non-interacting fermions of spin 1/2 into this box. To calculate the Fermi energy, we look at the case for N is large.

If we introduce a vector $\vec{n}=\{n_x,n_y,n_z\}$ then each quantum state corresponds to a point in 'n-space' with Energy

$E_{\vec{n}} = \frac{\hbar^2 \pi^2}{2m L^2} |\vec{n}|^2 \,$

The number of states with energy less than E_f is equal to the number of states that lie within a sphere of radius $|\vec{n}_f|$ in the region of n-space where n_x, n_y, n_z are positive. In the ground state this number equals the number of fermions in the system.

$N =2\times\frac{1}{8}\times\frac{4}{3} \pi n_f^3 \,$

The free fermions that occupy the lowest energy states form a sphere in momentum space. The surface of this sphere is the Fermi surface.

the factor of two is once again because there are two spin states, the factor of 1/8 is because only 1/8 of the sphere lies in the region where all n are positive. We find

$n_f=\left(\frac{3 N}{\pi}\right)^{1/3}$

so the Fermi energy is given by

$E_f =\frac{\hbar^2 \pi^2}{2m L^2} n_f^2 = \frac{\hbar^2 \pi^2}{2m L^2} \left( \frac{3 N}{\pi} \right)^{2/3}$

Which results in a relationship between the Fermi energy and the number of particles per volume (when we replace L² with V^2/3):

$E_f = \frac{\hbar^2}{2m} \left( \frac{3 \pi^2 N}{V} \right)^{2/3} \,$

The total energy of a Fermi sphere of $N$ fermions is given by

$E_t = {\int_0}^{N} E_f(N^\prime) dN^\prime = {3\over 5} N E_f$

Therefore, the average energy of an electron is given by:

$E_{av} = \frac{3}{5} E_f$

Other quantities defined in this context are Fermi momentum p_F and Fermi velocity v_F, the momentum and velocity, respectively, of a fermion at the Fermi surface. (These quantities are not well-defined in cases where the Fermi surface is non-spherical). In the case of the Fermi sphere, they are given by:^[2]

$p_F = \sqrt{2 m_e E_f}$

v F = p F / m e

where $m e$ is the mass of the electron.

Typical Fermi energies

White dwarfs

Stars known as white dwarfs have mass comparable to our Sun, but have a radius about 100 times smaller. The high densities means that the electrons are no longer bound to single nuclei and instead form a degenerate electron gas. The number density of electrons in a white dwarf are on the order of 10³⁶ electrons/m³. This means their Fermi energy is:

$E_f = \frac{\hbar^2}{2m_e} \left( \frac{3 \pi^2 (10^{36})}{1 \ \mathrm{m}^3} \right)^{2/3} \approx 3 \times 10^5 \ \mathrm{eV} \,$

Nucleus

Another typical example is that of the particles in a nucleus of an atom. The radius of the nucleus is roughly:

$R = \left(1.25 \times 10^{-15} \mathrm{m} \right) \times A^{1/3}$

where A is the number of nucleons.

The number density of nucleons in a nucleus is therefore:

$n = \frac{A}{\begin{matrix} \frac{4}{3} \end{matrix} \pi R^3 } \approx 1.2 \times 10^{44} \ \mathrm{m}^{-3}$

Now since the Fermi energy only applies to fermions of the same type, one must divide this density in two. This is because the presence of neutrons does not affect the Fermi energy of the protons in the nucleus, and vice versa.

So the Fermi energy of a nucleus is about:

$E_f = \frac{\hbar^2}{2m_p} \left( \frac{3 \pi^2 (6 \times 10^{43})}{1 \ \mathrm{m}^3} \right)^{2/3} \approx 30 \times 10^6 \ \mathrm{eV} = 30 \ \mathrm{MeV}$

The radius of the nucleus admits deviations around the value mentioned above, so a typical value for the Fermi energy usually given is 38 MeV.

Pinning of Fermi level

When the energy density of surface states is very high (>10¹²/cm²), the position of the Fermi level (work function as well) is determined by the neutral level of the surface states and becomes independent of doping concentration in a large range.

Free electron gas

In the free electron gas, the quantum mechanical version of an ideal gas of fermions, the quantum states can be labeled according to their momentum. Something similar can be done for periodic systems, such as electrons moving in the atomic lattice of a metal, using something called the "quasi-momentum" or "crystal momentum" (see Bloch wave). In either case, the Fermi energy states reside on a surface in momentum space known as the Fermi surface. For the free electron gas, the Fermi surface is the surface of a sphere; for periodic systems, it generally has a contorted shape (see Brillouin zones). The volume enclosed by the Fermi surface defines the number of electrons in the system, and the topology is directly related to the transport properties of metals, such as electrical conductivity. The study of the Fermi surface is sometimes called Fermiology. The Fermi surfaces of most metals are well studied both theoretically and experimentally.

The Fermi energy of the free electron gas is related to the chemical potential by the equation

$\mu = E_F \left[ 1- \frac{\pi ^2}{12} \left(\frac{kT}{E_F}\right) ^2 - \frac{\pi^4}{80} \left(\frac{kT}{E_F}\right)^4 + \cdots \right]$

where E_F is the Fermi energy, k is the Boltzmann constant and T is temperature. Hence, the chemical potential is approximately equal to the Fermi energy at temperatures of much less than the characteristic Fermi temperature E_F/k. The characteristic temperature is on the order of 10⁵ K for a metal, hence at room temperature (300 K), the Fermi energy and chemical potential are essentially equivalent. This is significant since it is the chemical potential, not the Fermi energy, which appears in Fermi-Dirac statistics.

References

^ The use of the term "Fermi energy" as synonymous with Fermi level (a.k.a. chemical potential) is widespread in semiconductor physics. For example: Electronics (fundamentals And Applications) by D. Chattopadhyay, Semiconductor Physics and Applications by Balkanski and Wallis.
^ Fermi level and Fermi function, from HyperPhysics

Kroemer, Herbert; Kittel, Charles (1980). Thermal Physics (2nd ed.). W. H. Freeman Company. ISBN 0-7167-1088-9.
Table of Fermi energies, velocities, and temperatures for various elements.
A discussion of Fermi gases and Fermi temperatures.

External links

Retrieved from "http://en.wikipedia.org/wiki/Fermi_energy"

Categories: Condensed matter physics | Statistical mechanics

The information on this page is provieded by courtesy of wikipedia.